Stahl G150 Series, Руководство по эксплуатации

Страница: 22 / 25

244375 / 815060300270
2015-06-24·BA00·III·en·00
Commissioning
9
Empty Enclosure
Series G150
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
8 Commissioning
Before commissioning, ensure the following:
• Check the mounting and installation.
• Inspect enclosure for damage.
• If necessary, remove foreign bodies.
• If necessary, clean the connection chamber.
• Check whether the cables have been inserted correctly.
• Check if all screws and nuts have been tightened firmly.
• Check whether all the cable entries and stopping plugs have been tightened firmly.
• Check whether all conductors have been clamped firmly.
• Check whether all covers and partitions for live parts have been installed and fastened.
• Seal unused cable entries using plugs with a respective certification and unused holes
with stopping plugs certified for the respective type of protection.
• Check the tightening torques.
The device is equipped with an internal and external protective conductor connection.
• Always connect the protective conductor.
• The external protective conductor connection is designed for cable lugs.
• Run and fix the cable near the enclosure.
• All blank, non-live metal parts have to be included in the protective conductor system,
regardless of the rated operational voltage.
• Neutral conductors are considered live conductors and have to be installed
accordingly.
• Ensure that inactive metal parts are insulated in accordance with
EN 61439-1/ IEC 61641 and not connected to PE.
9 Maintenance and repair
DANGER
Danger due to incorrect installation!
Non-compliance results in severe or fatal injuries.
• Check the device for proper installation before commissioning.
• Comply with national regulations.
NOTICE
Please observe further documentation, such as specification, circuit diagram etc.
WARNING
Risk of electric shock or malfunctioning of the device due to unauthorized
work!
Non-compliance can result in severe injuries and material damage.
• Work performed on the device must only be carried out by appropriately
authorized and qualified electricians.