Stahl 8146/03, Руководство по эксплуатации

Страница: 28 / 41

Mounting and Installation
8
137193 / 8146620300
2014-06-26·BA00·III·en·05
Control and Distribution Systems
Series 8146/5
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
7.2 Mounting / Dismounting, Operating Position
• Information regarding mechanical assembly, such as location of fastening points,
dimensions or weight of the switchgear combinations, is given in the enclosed
assembly drawing.
• Direct assembly or assembly by means of the frame system 8298 is possible.
(The frame system can only be used for the enclosures 8146/.7., 8146/.8. und 8146/.9.)
• Observe the weight of the enclosure according to the type and number of the built-in
components.
DANGER
Danger due to incorrect installation of the device!
Explosion protection is impaired!
• Carry out installation strictly according to the instructions and
national safety and accident prevention regulations to maintain the
explosion protection.
• Select and install the electrical device so that explosion protection
is not affected due to external influences, i.e. pressure conditions,
chemical, mechanical, thermal and electric impact such as
vibration, humidity and corrosion (see IEC/EN 60079-14).
• The device must only be installed by trained qualified personnel.
For this purpose, it is absolutely imperative to have the knowledge
of the relevant standards (e.g. IEC/EN 60079-14).
WARNING
Danger due to heavy weight!
Risk of injuries and material damage!
• Use suitable lifting tool.
• Secure against tilting.
Provide a protective roof or wall if explosion-protected electric equipment is
exposed to the weather.