Stahl 8118/1 Series, Руководство по эксплуатации

Страница: 32 / 49

Transport and Storage
8
133285 / 8118609300
2019-11-13·BA00·III·en·06
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
Terminal Boxes
Series 8118/1, Series 8118/2
4 Transport and Storage

Transport and store the device carefully and in accordance with the safety notes
(see Chapter "Safety").
5 Product Selection, Project Engineering and Modification
When complying with the installation conditions and specifications on the rating plate:

Check whether enough cable entries are provided. Create additional drilled holes if
necessary, see Chapter 5.1.

Equip terminals and, if necessary, mount built-in components;
see Chapter 5.3.
The primary methods considered for modification are remachining or retrofitting equipment
to the control and distribution boxes. The following options are available for this:
• Additional drilled holes in the enclosure either by R. STAHL (Chapter 5.1.1)
or by the customer (Chapter 5.1.2.1)
• External add-on components either by R. STAHL or by the customer (Chapter 5.2)
• Internal built-in components either by R. STAHL or by the customer (Chapter 5.3)
DANGER! Explosion if the entire device is completely painted after manufacture!
Non-compliance may result in serious or even fatal injuries.

Do not paint the device.

Have all repairs performed by the manufacturer.
DANGER! Explosion due to defective sealing of the device!
Non-compliance may result in serious or even fatal injuries.

Do not create any additional drilled holes to apply labels or plates (on the outside).

Equip the enclosure only with suitable equipment (e.g. cable entries,
stopping plugs, drain valves or breathers) that is verifiably approved for use in
hazardous areas and meets the requirements of the IP protection
(for approved Ex-Zone and IP, see rating plate).

Observe the operating instructions from the manufacturers of the components and
seals that are to be installed.

Seal any unused cable entries with the stopping plugs approved for the type of
protection.

Seal all open drilled holes by means of suitable equipment.
NOTICE!
Non-compliance can result in material damage.

Acceptance testing for work you performed must be carried out in accordance with
national regulations. Otherwise, you must have R. STAHL or a test body
(third-party inspection) (Chapter 3.3.1) carry out acceptance testing.
This can be done by R. STAHL on request based with a corresponding quotation.
If the work is carried out by R. STAHL, no additional acceptance is necessary.