Figure 76.
Group Monitor
4.1.7
ETS evaluation with BlueNRG-2 devices
To start ETS evaluation with
devices, you have to install and initialize your devices in the KNX system
through the ETS tool.
The configuration download has to be done from already built ETS projects.
4.1.7.1
TP/RF coupler configuration
Note:
The TP/RF coupler configuration needs to be performed only the first time.
Step 1.
Right-click on the device in the ETS tool to start download configuration and then select full download.
Figure 77.
TP/RF device full download
Step 2.
Push for few seconds the [
Prog
] button to switch to programming mode.
Figure 78.
Programming button
4.1.7.2
LED actuator application
Step 1.
Right-click on ETS RF line and address LED actuator application and start [
Full download
].
UM2920
ETS5 setup through Tapko RF/TP coupler
UM2920
-
Rev 1
page 44/71
