ST STEVAL-IOD04KT1, Руководство пользователя

Страница: 7 / 13

Step 10. To activate the data exchange with another sensor, go to [ Parameter Menu ]>[ Process Input
Selection ].
Step 10a. Double-click on the sensor name (green text).
Step 10b. Select the desired sensor from the available choices.
Step 10c. Click on [ Write Selected ] to align the master and device.
The procedure is completed when the name of the selected sensor becomes green, as shown below.
Figure 6. IO-Link Control Tool view (example)
Figure 7. IO-Link Control Tool view - process data plot
When you finish your evaluation session, follow the additional steps below.
Step 11. Click on [ Inactive ] to stop IO-Link communication.
Step 12. Click on [ Power Off ] to stop the IO-Link master from supplying the IO-Link device.
Step 13. Click on [ Disconnect ] to stop the communication between IO-Link Control Tool and P-NUCLEO-
IOM01M1 .
Step 14. Disconnect the mini-USB cable from the P-NUCLEO-IOM01M1 .
Step 15. Disconnect the 24 V supply from the P-NUCLEO-IOM01M1 .
UM2943
Hardware setup
UM2943 - Rev 1
page 7/13