Motor control operations
UM0522
28/39
Figure 16.
System setup for programming phase
1.
Use the USB cable to connect the inDART-STX board to the PC. The green LED on the
inDART-STX board turns on. The Windows® operating system automatically detects
the new hardware and loads the appropriate USB and inDART-STX drivers.
Note:
Windows 2000® and Windows XP® may issue a warning the first time the inDART-STX
power board is connected to the PC. The USB driver used by inDART-STX is not digitally
signed by Microsoft, however, the user may safely ignore the warning since every kind of
compatibility and security test has been carried out by Softec Microsystems.
2.
Connect the inDART board with the J7 connector using the 10-pin flat cable.
3.
Supply the control board using a 15 V power supply connected to CON2 observing the
polarity.
Once the ST7VD for inDART has been installed, the "datablaze programmer" utility that can
be used to program the firmware using the inDART-STX is automatically installed.
4.
Run the Softec datablaze programmer utility.
5.
Click the "select device" button on the toolbar.
6.
In the "select device" window, select "inDART-STX" in the "programmer hardware" box,
and "ST7FMC2S4" as the device code, and press OK.
www.BDTIC.com/ST
