UM0857
Getting started
Doc ID 16752 Rev 1
11/66
2 Getting
started
2.1 System
requirements
The system requires Li-Ion batteries (3.7 V, 1800 mAh) or suitable mini USB adaptors (5 V,
500 mA) for powering of the smart station (STEVAL-IFS014V1) and the node (STEVAL-
IFS015V1).
2.2 System
content
The complete system is comprised of the following:
●
Hardware
–
STEVAL-IFS014V1 (smart monitoring station), 1 USB cable and 1 stylus
–
Three STEVAL-IFS015V1 devices (smart monitoring nodes)
●
Software
–
GUI of the smart monitoring system
●
Documentation
–
User manual (this document)
Note:
The user should buy the STEVAL-IFS014V1 and STEVAL-IFS015V1 separately. These two
are different entities and together they comprise the smart monitoring system.
Note:
The smart monitoring system works as a standalone unit with either the STEVAL-IFS014V1
or STEVAL-IFS015V1. All the parameters are measured and displayed on the onboard
display. Adding one node to the smart station allows one to evaluate the wireless features
and the addition of two nodes would allow one to test the feature of simultaneous movement
of the nodes. Two additional quantities of the STEVAL-IFS015V1 are recommended only to
evaluate the complete system.
2.3 Hardware
installation
Both the smart monitoring station (STEVAl-IFS014V1) and smart node (STEVAL-IFS015V1)
can be powered by an external USB adaptor (5 V, 500 mA) or mini USB cable or by using
the 3.7 V Li-Ion battery.
www.BDTIC.com/ST
