ST STEVAL-IFP046V1, Руководство пользователя

Страница: 6 / 19

Step 2. Download the firmware (.bin) onto the STM32 Nucleo development board microcontroller through
STM32 ST-LINK utility , STM32CubeProgrammer and according to your IDE environment as detailed in
the table below.
Table 1. NUCLEO-F401RE development board supported IDEs - bin files
NUCLEO-F401RE
IAR Keil STM32CubeIDE
EWARM-OUT05_06-
STM32F4xx_Nucleo.bin MDK-ARM-OUT05_06-
STM32F4xx_Nucleo.bin STM32CubeIDE-OUT05_06-
STM32F4xx_Nucleo.bin
Table 2. NUCLEO-G431RB development board supported IDEs - bin files
NUCLEO-G431RB
IAR Keil STM32CubeIDE
EWARM-OUT05_06-
STM32G4xx_Nucleo.bin MDK-ARM-OUT05_06-
STM32G4xx_Nucleo.bin STM32CubeIDE-OUT05_06-
STM32G4xx_Nucleo.bin
Step 3. Connect the IPS1025HQ-32 device supply voltage via CN1 (see Section 1.1.2 Power section ).
Step 4. Provide the digital supply voltage (see Section 1.1.1 Digital section ).
Step 5. Connect the load on the output connector (see Section 1.1.2 Power section ).
Step 6. Reset the example sequence using the black push button.
Step 7. Push the STM32 Nucleo blue button to select the example provided in the firmware package.
1.5 Multiple board configuration
It is also possible to evaluate a four channel digital output module by stacking four STEVAL-IFP046V1 with shared
or independent supply rail and independent loads.
In this case, the four expansion boards (board 0, 1, 2, 3 as shown in the table below) must be properly configured:
for board 1, 2 and 3, it is necessary to unsolder three resistors for each board from the default position and solder
them back in the alternate positions according to the following table.
Table 3. Configuration of a stack of four expansion boards
Board no. IN1 FLT1 FLT2
Board 0 R101 R103 R114
Board 1 R102 R104 R117
Board 2 R115 R116 R107
Board 3 R120 R119 R118
UM3058
Multiple board configuration
UM3058 - Rev 1
page 6/19