ST ST72F651, Руководство пользователя, Страница: 16 / 30

USB power/GUI mode of evaluation board UM0452
16/30
Figure 11. Temperature sensor window
4.3.5 Address checking using GUI
After the sensor package is selected and address is selected on the board (as stated in
Section 4.3.1 ), the address is sent from the GUI through the drop down menu of Choose
Address. If the address sent by the GUI does not match the address setting done on the
board, an error message pops up on GUI as shown in
Figure 12 , in which case, check the
address setting on the board and the address sent by GUI. Reset the address and then
recheck the address. When the addresses match, the temperature sensor window becomes
active and the default settings of the sensor registers are displayed on GUI as shown in
Figure 13 .