Getting started with the demonstration
UM1784
6/18
DocID026524 Rev 2
2
Getting started with the demonstration
2.1 Hardware
requirements
The hardware requirements to start the demonstration application are as follows:
•
STM32F302R8, STM32F303RE or STM32F334R8 Nucleo boards
•
Adafruit 1.8" TFT shield with Joystick and microSD (reference ID: 802)
•
one 'USB type A to Mini-B' cable to power up the STM32 Nucleo board from the USB
ST-LINK (USB connector CN1)
•
a Standard Capacity SD card (SDSC) with a capacity up to 4GBytes.
2.1.1
STM32F302R8, STM32F303RE or STM32F334R8 Nucleo boards
The STM32 Nucleo board is a low-cost and easy-to-use development kit to quickly evaluate
and start some development with ARM
®
32-bit Cortex
®
-M microcontrollers of the STM32
series (STM32F103, STM32F030, STM32F072, STM32L152 and STM32L053). Before
installing and using the product, please accept the Evaluation Product License Agreement
available at www.st.com/epla.
For more information on the STM32 Nucleo board visit www.st.com/stm32nucleo.
Figure 2. STM32F302 Nucleo board