St. Jude Medical Axium, Руководство пользователя

Страница: 21 / 36

17
Stimulator Binding
Your doctor will bind and unbind your Stimulator to your Programmer. You cannot edit
this information.
Magnet
A magnet is located under the magnet symbol on the back side of the Programmer.
Place the magnet over the Stimulator to initiate connection between the Programmer
and Stimulator. See the “Connecting with Your Stimulator” section below for more
detail.
Magnet
Location
Connecting with Your Stimulator
Use your Programmer to communicate with your Stimulator.
• Turn ON your Programmer. The Main Menu will display.
• Press the “Connect” button. The Programmer will begin searching for the
Stimulator. An icon shows on the screen to show that it is busy.
• Hold the magnet on the Programmer over your Stimulator and move it around in a
circular motion to start communication.
• The Programmer chimes when it is connected to your Stimulator. Hold your
Programmer steady over your Stimulator for a few seconds after the chime. The
Pain Control screen will then display. “Connected” shows in the status bar at the
bottom left of the screen. If your Programmer cannot connect to your Stimulator
(~10 s), an error message displays. “Disconnected” shows in the status bar.
• If your Programmer cannot connect to your Stimulator, go back to the Main Menu.
Press “Connect” again. Move the magnet in a circular fashion over your Stimulator.
Repeat until the Programmer connects to the Stimulator.
• Your Programmer should always be held near your Stimulator to maintain a good
connection (~1 ft / 30 cm).
NOTE: If after two minutes your Programmer cannot connect to the Stimulator,
place the Programmer over the Stimulator again. An error message may
display. The message asks you to confirm that your Programmer is near
enough to the Stimulator. After confirming that your Programmer is near
your Stimulator, press “OK”. Press “Connect” again.