SST SST-ASI-SLC, Руководство пользователя

Страница: 37 / 74

Configuring the Master and Slaves
31
6.2 Configuring the Scanner Using PLC-500
Ladder Logistics
When you program your SLC system using PLC-500 Ladder Logistics, use
the following steps to set up the scanner. This procedure only works with
version 8.15 and above of PLC-500 Ladder Logistics. Earlier versions do not
support setting the G file size or editing the G file.
1. Create a new program offline.
2. Select the SLC processor, memory and operating system.
3. Select the rack number for the scanner and the rack size.
4. Select the slot in which the SST-ASI-SLC is located, then press F5
(Select) to configure the scanner.
5. Select Other and enter the scanner ID code (13635).
6. Select spioCfg.
7. Press F1 M0 length and set the M0 file size to 40
8. Press F2 M1 length and set the M1 file size to 40.
Refer to section 7.3 for additional information on the M files.
9. Press F6 for G Data Words and set to 64.
10. Press F7 to edit G data. Configure the G file to match your network
configuration.
Refer to section 7.1 for more information on the G file setup.
11. When finished, press Esc to exit the G file editor.
12. Press Esc to exit spioCfg.
13. Press Esc again to create the files.
14. Create the rest of your control program.
15. Exit the programming software and save the configuration and the
program.
16. Transfer the program to the SLC.