SST SST-ASI-SLC, Руководство пользователя

Страница: 36 / 74

SST-ASI-SLC User’s Guide
30
6.1 Configuring the Scanner in APS
When you program your SLC system in APS, use the following steps to set
up the scanner:
1. Create a new program or modify an existing program in offline
mode.
2. Select the SLC processor, memory and operating system.
3. Select Configure I/O.
4. Configure the rack type. Select F4 Modify Racks, select the rack
number and set the type of rack.
5. At this point, if you are connected to the SLC, you can select Read
Config to read the configuration from the rack, select SPIO Config
and go to step 12.
6. Select the slot where the SST-ASI-SLC is located, then select
Modify Slot. Select Other and enter the scanner ID (
13635
).
7. Select SPIO Config.
8. Select Advanced Setup.
9. Set the M0 and M1 file sizes to 40 words.
Refer to section 7.3 for additional information on the M files.
10. Set scanned inputs and scanned outputs to 32 words.
11. Escape from advanced setup.
12. Set the G file size to 64 words.
13. Select Modify G file. Configure the G file to match your network
configuration.
Refer to section 7.1 for more information on the G file setup.
14. Write the rest of the ladder logic.
Refer to section 7.2 and section 7.3 for information on the I, O and
M files.
15. Exit configuration and save the configuration and the program.
16. Transfer the program to the SLC.
You can configure your slaves using a handheld addressing unit or via the
serial port. See section 6.5 for an example of slave configuration.