SSI Single Gas Analyzer for H2, Руководство по эксплуатации

Страница: 7 / 44

Single Gas Analyzer (SGA)
Operations Manual
Super Systems Inc. Page 7 of 44 Page 7 of 51
Initial Network Configuration
This section is intended for use by persons familiar with Ethernet network setup.
In order to work correctly, the unit must be properly configured for the network to which it is
connected. To locate the unit’s IP address, first connect the unit to an Ethernet network using
the appropriate cable.
If you already know the IP address of the web interface, skip to the
The Read/Write Registers page gives access to the underlying Modbus registers of the SGA.
This page is primarily intended for testing and troubleshooting purposes.
Please contact SSi before attempting to make any changes to the settings on this page.
Network Configuration section on page 30. The network configuration is described in this
section.
The IP address of the unit can be found by using SSi’s
nLocateIP
software. This method is
described in the following subsection.
nLocateIP Method
Once the unit is connected to the network, you should be able to locate it on the network using
SSi’s
nLocateIP
software. This program is available from SSi. To use it in locating the unit on
the network, follow these steps on a Windows-based PC:
1. Ensure that the unit is connected to the
network.