All-in-one Solar Energy Storage Inverter Controller
8
2. Installation Instructions
2.1 Installation considerations
Read this manual carefully and familiarize yourself with the installation procedures
before installing.
Be very careful when installing the battery, and wear protective goggles when
installing lead-acid liquid battery. Once in contact with the battery acid, rinse the
contact part with water in time.
Avoid placing metal objects near the battery to prevent a short circuit.
Acidic gases may be generated when the battery is charged, so make sure the
environment is well ventilated.
When installing the cabinet, be sure to leave enough space around the machine for
heat dissipation; do not install the machine and the lead-acid liquid battery in the
same cabinet, so as to avoid the acid gas generated when the battery works that may
corrode the machine.
Only charge the battery that meets the requirements of this all-in-one machine.
The false connection points and corroded wires may generate great heat that may
melt the wire insulation, burn the surrounding material, or even cause fire, so make
sure that the connectors are tightened, and the wires should be fixed with ties to avoid
shaking when moving the machine, causing the connectors to be loose.
The system connection wires should be selected according to the current density of
not more than 5A/mm2.
When installing outdoors, avoid direct sunlight and rainwater infiltration.
When the power is turned off, there is still a high voltage inside the machine, so do
not open or touch the internal components and wait for the capacitor runs out of
power.
Do not install the all-in-one machine in harsh environments such as wet, greasy,
flammable, explosive or dusty.
Do not reverse the polarity of the battery input end of this product, otherwise the
equipment may be easily damaged or unpredictable danger may occur.
The mains input and AC output are high voltage, so do not touch the wire
