Important safety instructions
Please keep this manual for future reference
The user manual contains all safety, installation, and operation instructions for the HT series all-in-one solar
energy storage inverter controller.
Please read all instructions and precautions in the manual carefully before installation and use.
There is unsafe voltage inside the all-in-one machine, so in order to avoid personal injury, users shall not
disassemble themselves, and should contact the company s professional maintenance personnel for repair.
Do not place the all-in-one machine in a place where children can reach it.
The
protection
grade
of
the
all-in-one
machine
is
IP20.
It
is
an
indoor
application
product.
It
is
strictly
prohibited
to
use
outdoors.
Do not install the all-in-one machine in harsh environments such as wet, greasy, flammable, explosive or dusty.
The mains input and AC output are high voltage, so do not touch the wire connections.
When the all-in-one machine is operating, the temperature of its enclosure is very high, so do not touch it.
Do not open the terminal protection cover while the all-in-one machine is operating.
It is recommended to install a suitable fuse or circuit breaker on the exterior of the all-in-one machine.
Always disconnect the fuse or circuit breaker near the PV array, mains and battery terminals before installing
and adjusting the wiring of the all-in-one machine.
After installation, check that all wiring connections are tight to avoid the risk of heat build-up due to false
connections.
The all-in-one machine is off-grid type, it is necessary to confirm that it is the only input device for loads as
needed and it is prohibited to use it in parallel with other input AC power to avoid damage.
All-in-one Solar Energy Storage Inverter Controller
2
