SRAM RockShox Vivid Air R2, Техническое руководство, Страница: 8 / 27

GEN.0000000003161 REV A 8
MounTinG hARdWARE inSTALLATion
MounTinG hARdWARE inSTALLATion
Some mounting hardware is easily installed
using only your fingers. Press the bushing
pin into the shock eyelet bushing until the
pin protrudes from both sides of the eyelet
an equal amount. Then press an end spacer,
large diameter side first, completely onto each
end of the bushing pin. If this works, you have
completed mounting hardware and bushing
service.
If you are unable to install your mounting
hardware using your fingers, use the SRAM rear
shock bushing installation and removal tool.
Thread the push pin onto the threaded rod, small 1.
diameter end first, until the rod is flush with or
slightly protrudes from the hex-shaped end of
the push pin.
Insert the threaded rod through the bushing 2.
pin then through the shock eyelet so that the
bushing pin is positioned between the push pin
and the shock eyelet.
On the opposite side of the shock eyelet, thread 3.
the catcher, opening side first, along the rod until
it rests against the shock eyelet.
Clamp the catcher in a vise or hold it secure with 4.
a 13 mm or adjustable wrench. Use a second 13
mm open ended wrench, an adjustable wrench,
or a socket wrench with a 13 mm socket to
thread the push pin along the rod so that it
pushes the bushing pin into the shock eyelet
bushing. Continue to thread the push pin and
push the bushing pin into the shock eyelet
bushing until the bushing pin protrudes from
both sides of the eyelet an equal amount (you
may need to unthread the catcher slightly to
check the bushing pin spacing).
Unthread the catcher from the threaded rod and 5.
remove the tool from the shock eyelet.
Use your fingers to push an end spacer onto 6.
each end of the bushing pin, with the large
diameter side of the spacers facing the shock
eyelet.
1 2
4
3
6