5
RockShox Service
R o c k S h o x S e r v i c e
We recommend that you have your RockShox suspension serviced by a qualified bicycle mechanic. Servicing RockShox suspension requires
knowledge of suspension components, as well as the use of specialized tools and lubricants/fluids. Failure to follow the procedures outlined in this
service manual may cause damage to your component and void the warranty.
Visit
RockShox Spare Parts Catalog
and technical information. For order information, please contact your local
SRAM distributor or dealer.
Information contained in this publication is subject to change at any time without prior notice.
Your product's appearance may differ from the pictures contained in this publication.
For recycling and environmental compliance information, please visit:
www.sram.com/en/company/about/environmental-policy-and-recycling
P a r t P r e p a r a t i o n
Remove the component from the bicycle before service.
Clean the exterior of the product with mild soap and water to avoid contamination of internal sealing part surfaces.
S e r v i c e P r o c e d u r e s
The following procedures should be performed throughout service, unless otherwise specified.
Clean the part with isopropyl alcohol or RockShox Suspension Cleaner and
Clean the part with isopropyl alcohol or RockShox Suspension Cleaner and
a clean, lint-free shop towel. For hard to reach places (e.g. upper tube, lower
a clean, lint-free shop towel. For hard to reach places (e.g. upper tube, lower
leg), wrap a clean, lint-free shop towel around a non-metallic dowel to clean
leg), wrap a clean, lint-free shop towel around a non-metallic dowel to clean
the inside.
the inside.
Clean the sealing surface on the part and inspect it for scratches.
Clean the sealing surface on the part and inspect it for scratches.
Replace the o-ring or seal with a new one from the service kit. Use your
Replace the o-ring or seal with a new one from the service kit. Use your
fingers or a pick to pierce and remove the old seal or o-ring.
fingers or a pick to pierce and remove the old seal or o-ring.
Apply grease to the new seal or o-ring.
Apply grease to the new seal or o-ring.
NOTICE
Do not scratch any sealing surfaces when servicing the product. Scratches
can cause leaks. Consult the
RockShox Spare Parts Catalog
to replace the
damaged part.
Use Reverb Vise Blocks when clamping Reverb parts in a bench vise.
Use Reverb Vise Blocks when clamping Reverb parts in a bench vise.
Tighten the part with a torque wrench to the torque value listed in the red bar.
Tighten the part with a torque wrench to the torque value listed in the red bar.
When using a crowfoot socket and torque wrench, install the crowfoot socket
When using a crowfoot socket and torque wrench, install the crowfoot socket
at 90 degrees to the torque wrench.
at 90 degrees to the torque wrench.
Specified torque value in N·m (in-lb)
