25
Damper Service
D a m p e r S e r v i c e
2 0 0 H o u r S e r v i c e
C h a r g e r D a m p e r R e m o v a l
NOTICE
Inspect each part for scratches. Do not scratch any sealing surfaces
when servicing your suspension. Scratches can cause leaks.
When replacing seals and o-rings, use your fingers or a pick to remove
the seal or o-ring. Spray isopropyl alcohol on each part and clean with a
rag. Apply SRAM Butter grease to the new seal or o-ring.
RCT3:
Turn the low speed compression and compression mode
adjuster knobs counter-clockwise until they stop, to the full open
positions.
The compression damper must be in the full open position in order to
perform the bleed procedure.
RC:
Turn the low speed compression adjuster knob counter-clockwise
until it stops, to the full open position.
The compression damper must be in the full open position in order to
perform the bleed procedure.
1
RCT3
Low speed
RCT3
Compression mode
RC
Low speed
