Model SRV415 Multi-Purpose Floor Scale
Service Manual
Part No. MAN415
_
200714
Page 8 of 14
S
Instruments, Inc.
,
600 Young Street, Tonawanda, NY 14150
Tel: 716-693-5977 Fax: 716-693-5854 URL:
www.srscales.com
email:
Copyright 2020
S
Instruments, Inc.
BASIC SYSTEM OPERATION
SETTING SYSTEM ZERO:
Make sure the scale is free and clear of any obstructions. Press and hold the
“
Zero/Weigh
” button to zero the system. In a few seconds, the display will read
“
0.0 Lb
” (or
0.0 kg
). It is recommended that the system be zeroed prior to each
use.
The display will indicate weight in either pounds or kilograms. If scale shuts down, press the
“
Zero/Weigh
” button once to wake display and take reading.
HOLD/RECALL:
The scale display is designed to automatically lock the reading on the display and
store the reading in memory, once the weight is stable. If scale cannot lock in
reading due to movement, press the “
Hold/Recall
” button to automatically lock
the display and store the reading.
To return to
WEIGH
mode when finished, press the “
Zero/Weigh
” button once. The display will
become active.
Once the scale has shut down, the last stored weight can be recalled by pressing the “
Hold/Recall
”
button. The last stored weight will be displayed until the scale shuts down or the “
Zero/Weigh
”
button is pressed.
DISPLAY INDICATORS
Scale is zeroed and stabilized
Applied weight load has stabilized
BATTERY REPLACEMENT
The display will read “
LobAt
” when batteries are low and need to be changed.
STEP 1
: Turn the scale over and locate the battery cover (Figure 1). Press the latch in and remove
the battery cover.
STEP 2
: Remove and replace all six (6) 1.5 volt “AA” batteries.
STEP 3
: Press the “
Zero/Weigh
” button to confirm display is working.
STEP 4
: Place battery cover back on and secure latch in place.
STEP 5
: Zero the system.
o
