Once the screw has been removed draw the
bolt back to its stop position. Lift the bolt
knob and draw back to a second stop
position. Push it down to lock it in this
recoding position.
Tel: 01902 308050 Fax: 01902 308051
E-Mail: [email protected] Website: www.squirelocks.co.uk
Henry Squire & Sons Limited
Hilton Cross Business Park, Cannock Road, Featherstone, Wolverhampton, WV10 7QZ
Fitting and Recoding Instructions
Combi
-Bolt
3
3.
4.
Using the bolt and keep as a template
mark the screw positions. Drill pilot holes
for the screws. (Use 3.5mm drill bit).
Use the security screw provided and
firmly screw into position. (Note these
security screws cannot be undone).
After fitting the bolt use it to position
the keep plate. Mark it's position and
recess it into the frame.
Drill the pilot holes as in 1. above and,
using the security screws, secure the
keep plate.
On external installations always lock the
bolt even in the open position (This will
prevent unauthorised recoding).
Flush Fitting
Remember
2.
2.
The bolt is factory set on 000. Before you
can recode the CombiBolt3 you need to
remove the screw marked in the diagram
above.
TM
1.
Recess Fitting
(Where required)
1.
0
Remove screw before
recoding
Carefully rotate the coding wheels to the
desired number, taking care to align them to
the coding mark.
(Make a note of the new
code number).
Without moving the wheels reverse the
procedure of 1. The new code is now set.
? ? ?
3.
Put the security screw back.
4.
0
0
How to recode
TM
GB
