www.squarejellyfish.com
Designed in USA. Made in China. Patents pending.
Thank you for purchasing the new Spring Tripod
Mount. This product was designed to hold a
smartphone, MP3 or pocket camera that is 2 ¼”
to 3 ⅝” in width with a weight up to 8 ounces.
Set up your personal tripod
• Once your tripod is on level ground and completely
stable, screw on the Tripod Mount.
Attach your device
• Flip each of the two Spring Tripod
Mount claws open forming 90
degree angles with the rest of the
claw assembly.
• Loosen the rear knob and rotate
claw assembly into vertical or
horizontal camera position. For
added positioning flexibility, claw
assembly can slide left to right or up and down on the
end of the knob if desired. Thumb-tighten rear knob.
• Gently pull claws in opposite
directions until your device easily
slides into place. Release claws.
Tension will hold your device
securely in the mount.
• Once the device is mounted,
it can easily be rotated between
vertical and horizontal camera
positions. Temporarily lightly loosen knob if necessary.
Use common sense
• Do not carry the tripod with your device installed. When
you move the tripod, remove the device.
• This product is designed to hold a device steady on
a tripod while taking a picture. It is not designed to be
mounted to a moving object or vehicle.
• This product contains small parts that may be a choking
hazard. Keep out of reach of children.
SqUAre JellyfiSh Spring tripod moUnt USer’S mAnUAl
for vertical
photos
for horizontal
photos
