SQlab
|
SPOR
TS ER
GONOMICS
|
7
02, 7
10
, 7
11 AND 7O
X
|
EDITION US 2
019-01
|
P
ag
e
10
Inspection and maintenance
Care
Check the clamping and surface of the grips for possible damage at least twice a year, after 2000 km at the latest and especially after falls
or other situations of unusually high force.
Clean the SQlab grips regularly with water and a soft cloth. For heavy soiling, a commercially available rinsing or cleaning agent and warm
water can be used.
For SQlab 702 and 710 grips, at first the
grip should be set so that the writing at the
end of the grip is horizontal. Starting from
there, you must align the grip with your sit-
ting position and wrist position.
Warning
Do not set the wing too high for 710 and 702. The wing should only support the hand
while riding and under normal pressure.
• Although a wing that is set too high would rightfully prevent the wrist from bending
downwards, it may interfere with grip at higher speeds and correspondingly higher
forces.
• Note the ergonomics tips on www.sq-lab.com in the category Ergonomics – Hand.
Warning
Damage may be difficult to detect. A cracking or creaking noise, as well as discoloration, cracks, and waves in the grip's clamping
side and surface may indicate damage.
• If in doubt, do not continue cycling and consult your SQlab dealer without delay.
Warning
Never use high pressure cleaners, cleaning cloths or sponges with particularly rough or grainy surfaces, solvents or other aggressive
cleaning agents such as acetone, (nitro) thinner, cleaning bezine or trichlorethylene for cleaning. This could damage the clamping
or the surface of the grips.