SPXFLOW Seital Separation SE 40CX-Q2P2, Инструкция по эксплуатации

Страница: 9 / 126

Chapter 2
Rev. 1 of 14/01/97
SEITAL S.r.l.
Use and maintenance handbook: Centrifugal separator
SE 40CX
Page 2-3
2.3.6. Foreseeable errors and incorrect behaviours
To avoid eventual errors and/or mistakes, it’s necessary that operating procedures and danger
warnings reported in this Handbook, are well known from the whole personnel.
2.3.7. List of used symbols and warnings
The symbols used as stickers on the machine, to point out the dangers during use and
maintenance are described at § 7.2.3.
In the following pages of the Handbook the relevant information regarding safety are shown
into suitable square with the notice “ATTENTION”.
ATTENTION
This notice want to recall the attention of the reader on danger zones or movements.
2.3.8. Safety prescriptions
In the following pages are indicated the important safety precautions to observe in machine
use.
General prescriptions:
a) Cure the operating space around the machine, which must be free from obstacles, clean and
adequately lighted.
b) Every machine intervention must be performed by authorized personnel and with the
prescribed operators number.
c) Eliminate every dangerous condition for safety before using the machine and always
inform the maintenance responsible about any eventual working trouble.
d) It is forbidden productive operation with safety devices disconnected or fixed shields
removed.
e) Do not let the machine with disassembled shields.
f) It is forbidden any modification for adjustment of objects/devices not provided by the
manufacturer. Use only SEITAL spare parts.
g) Do not execute weldings and flame heating on the bowl parts .
h) Never use the machine if damaged.
i) The separator must be only connected with power and control panel specifically delivered
by SEITAL for the separator.
j) In case power and control panel has not been supplied with separator, and electrical
connection has been made not in conformity with the instructions reported on enclosed
wiring diagram, SEITAL will consider itself exempted from every responsibility regarding
people safety and the defective working of the machine.
k) The electric panel must always be closed.
l) The key to open electric panel must be entrusted to a specialized and learned person or to a
responsible of the department in which the machine works.
m)Before initial start-up perform every check reported in § 7.7.
n) The maximum operating speed allowed for the bowl is 6.500 r.p.m.
o) Never transport or lift the separator with its bowl installed.
p) Never mount the machine