SPXFLOW Seital Separation SE 40CX-Q2P2, Инструкция по эксплуатации

Страница: 75 / 126

Chapter 10
Rev. 2 of 19/01/98
SEITAL S.r.l.
Use and maintenance handbook: Centrifugal separator
SE 40CX
Page 10-7
n° TROUBLE CAUSE REMEDY

Filter cartridge obstructed. Replace cartridge.
Water pressure switch (PSC4
Tab. 21) out of use. Check correct working of surge
tank.
Worn-out gaskets of bowl
valves (Tab. 03).
Replace gaskets.
12 Leakage of product from solids
discharge pipe.
Excessive pressure. Increase pressure value at
buttermilk outlet, unscrewing
the shutter A or regulator RPL
(fig. 7.4), if present.
It is worn one of the following
gaskets:
- upper finned disk gasket (10)
fig. 6.1.
Replace gasket.
- nylon gasket (11) fig. 6.1. Replace gasket.
- drilled gasket of dividing disk
(15) fig. 6.1.
Replace gasket.
13 Leakage of cream from solids
discharge pipe.
Excessive cream pressure. Unscrew cream shutter (B - fig.
8.1)
and reduce buttermilk
pressure if the same cream
density is required.
14 Insufficient cream
concentration
Capacity too high. Reduce the capacity.
Solids chamber filled. Reduce time between two
consecutive discharges.
Disks column obstructed. Disassemble and clean. Check
the cleaning cycle.
Product temperature not
suitable.
Preheat product at the process
temperature.
Wrong regulation. See chapter 8.1
Dividing disk is not correctly
placed. Check it is placed in the right
way.
It is worn one of the following
gaskets:

- upper finned disk OR gasket
(10) fig. 6.1.
Replace gasket.