SPXFLOW Seital Separation SE 40CX-Q2P2, Инструкция по эксплуатации

Страница: 49 / 126

Chapter 7
Rev. 3 of 02/05/03
SEITAL S.r.l.
Use and maintenance handbook: Centrifugal separator
SE 40CX
Page 7-3
CONNECTED
COLLEGATO
400
VOLT
• On the electric panel door:
DANGER OF ELECTROCUTION
• On the motor connection box (if electric panel is not present) or under the padlockly
block-door command of electric panel:
GENERIC ALERT
MOTOR TERMINAL BOARD IS PREDISPOSED TO BE
CONNECTED TO A “400 V” LINE
It’s absolutely necessary to recognize the meaning of the warning bill-stickings and maintain
the message readable. In case of deterioration, the stickings must be immediately substitued
avoiding the use of the machine until it’s unprovided with them.
It’s recommended to comply with the remarks referred on the stickings.
ATTENTION
The following paragraphs refer to a machine equipped with a standard electric panel. If this is
not supplied with the separator, make electrical connection according to wiring diagram and
the following instructions. The operating procedures, reported below, must be respected too.
7.3. Control, regulation and signaling devices
7.3.1. Controls and signals
On control panel , there are the following commands (Fig. 7.1):
- padlockly block-door command (QS1) 0-1 black-red coloured;
- ammeter (A) - current intensity indicator of separator motor;
- (SB0) red-yellow mushroom head emergency button to emergency stop.
- (SB1) push button (with green guard HL1) to start separator motor.
- (SB2) black push button to stop the separator motor.
- (SB4) push button (with green guard HL4) to start pump motor
- (SB3) black push button to stop pump motor
- terminal board with: