Chapter 6
SEITAL S.r.l.
Rev. 3 of 01/12/04
Page 6-14
Use and maintenance handbook: Centrifugal separator
SE 40CX
ATTENTION
When disassembling is suggested to put in a suitable area the dismantled components to make
easier finding them out and to verify the completeness of the assembly at the end of it.
Proceed in inverse order than assembly (see Fig. 6.27).
1)
Disconnect feeding pipe and outlet pipes.
2)
Using the spanner (09.200.0 - Tab. 09) unscrew the nut (17) - left-handed thread.
3)
Using the spanner (09.010.0 - Tab. 09) block the feeding pipe and unscrew the ring nut
(15) - left-handed thread - using spanner (09.200.0).
4)
Extract the nylon washer (14).
5)
Unscrew the two screws (04.100.0 - Tab. 04), that fix the inlet-outlet flow unit to the
cover.
6)
Lift up the inlet-outlet body (9 and 13).
7)
Unscrew the 8 screws M10x30 (08.030.0 - Tab. 08).
8)
Lift up cover by hands or hoist, paying attention to not damage the thread of feeding pipe.
6.5.
Bowl disassembly
1)
By the spanner (09.190.0), unscrew (left-handed thread) the
small lock ring
.
2)
Remove the
finned cover.
3)
Take out the
buttermilk
pump.
4)
Remove the
dividing disk.
5)
Extract the
feeding pipe
and the
cream pump
.
6)
Take out the
drilled gasket of the dividing disk.
7)
By the spanners (09.060.0
09.090.0), compress the
disks stack
(Fig. 6.18). To make
this, perform the above mentioned operations.
- Lay bell (1) on bowl hood.
- Screw tight threaded rod (4) on the distributor.
- By using extension pipe (09.020.0) screw nut (3) as much as possible and anyhow until
the bowl hood completely lay on the corresponding seat of the bowl body.
- When the nut (3) lay on the flange (1), one turn is enough to slightly lift the distributor
from bowl body.
The spanner for compression disks stack also allows to check if disks compression is
correct. Infact one manual turn of nut (3 - Fig. 6.18), by means of extension pipe, must
cause a “sensation of toil”. If after one turn it is still hard to loosen the spanner it means
that one or two more disks are still necessary.
Содержание Seital Separation SE 40CX-Q2P2
