SPXFLOW Seital Separation SE 40CX-Q2P2, Инструкция по эксплуатации

Страница: 37 / 126

Chapter 6
Rev. 3 of 01/12/04
SEITAL S.r.l.
Use and maintenance handbook: Centrifugal separator
SE 40CX
Page 6-9
16) By the spanner (09.150.0) screw the
big lock ring (Fig. 6.20) that has left-
handed thread. This operation must be
performed
with the disks stack
compressed by the suitable spanner. It
must be possible screw by hands the
ring until the “0” mark is at least 1 cm.
before the “0” mark of the bowl body
(if this does not happen, it means that
the assembly is not correct or the
number of disks is wrong). Then fasten
it down as much as possible by striking
with mallet (09.030.0) the spanner
handle. Now the “0” marks must be
aligned. In case the bowl is not new
and the parts start being worn, the “0”
mark of the ring will go beyond the “0”
mark of the bowl body. The distance
between the two references must not
exceed 3 cm.
17) Remove the spanner for disks set compression. This spanner also allows to check if disks
compression is correct. Infact one manual turn of nut (3 - Fig. 6.18), by means of
extension pipe, must cause a “sensation of toil”. If after one turn it is still hard to loosen
the spanner it means that one or two more disks are still necessary.
18) After carefully cleaning the grooves,
insert the OR gaskets on feeding pipe
and on the centripetal pumps (see Fig.
6.27).
19) Insert the feeding pipe of product and
the cream centripetal pump (Fig.
6.22).
Figure 6.21
Before locking the
big lock ring
unscrew the 2
screws plug and
locking the spanner
(09.150.0)
screwed
the 2 screws
TE M 12x 40 with
washers Ø12 in the
correspondent holes.
Figure 6.22