SPXFLOW Seital Separation SE 40CX-Q2P2, Инструкция по эксплуатации

Страница: 33 / 126

Chapter 6
Rev. 3 of 01/12/04
SEITAL S.r.l.
Use and maintenance handbook: Centrifugal separator
SE 40CX
Page 6-5
8) Insert the disks (fig. 6.10). The disks
can be inserted in the distributor only in
one way. Over the distributor is marked
a big “O” that must be aligned with
“O” marks of the bowl body and
moving ram, and a small “o” which
indicates the angular position of disks
insertion. The disk must be inserted in
such a way that the small slot made on
the internal upper edge glides on the
distributor fin marked with the small
“o”.
Then insert:
- bottom disk (7 - Fig. 6.1) that
distinguishes itself by having
spacers on both surfaces.
- the three intermediate disks with
higher spacers;
- the intermediate disks (8);
- the four top disks with higher
spacers.
Take care to not change the sequence
of the disks
.
9) After carefully cleaning the groove,
insert the
OR gasket on the finned
upper disk (Fig. 6.11).
10) Insert the finned upper disk (Fig.
6.12), that distinguishes itself from the
other disks for the higher thickness and
for the shimming fins.
Figure 6.10
Figure 6.11
Figure 6.12