SPXFLOW Seital Separation SE 40CX-Q2P2, Инструкция по эксплуатации, Страница: 32 / 126

Chapter 6
SEITAL S.r.l. Rev. 3 of 01/12/04
Page 6-4 Use and maintenance handbook: Centrifugal separator
SE 40CX
- Slightly unscrew the threaded rod
until the ram is completely placed on
his seat. Could be necessary give
some plastic hammer blows on the
upper edge of the threaded rod
and/or on the upper edge of the ram
to make swinging the piece (fig.
6.8).
- The moving ram should be now
resting on the internal edge of the
bowl body. The most internal part of
the ram must be at about 3 mm.
under the hub of bowl body. This
position will be easily reached if the
steps from 3) to 6) have been
correctly made.
7) By the spanner (09.060.0

09.070.0),
screwed in the threaded hole present on
the upper edge of the
distributor , lift
the piece and place it down on his seat
(fig. 6.7). Check the guide pins of the
bowl body correctly rest on the suitable
seat of the distributor so that the whole
piece is uniformly resting on the bowl
body.
Figure 6.9
Figure 6.8