SPXFLOW Seital Separation SE 40CX-Q2P2, Инструкция по эксплуатации, Страница: 10 / 126

Chapter 2
SEITAL S.r.l. Rev. 1 of 14/01/97
Page 2-4 Use and maintenance handbook: Centrifugal separator
SE 40CX
q) Always carry out chemical cleaning at the working end and, in case of long dwell,
clean bowl carefully (see § 5.5.1).
r) If unusual vibration occurs:
- increase immediately the liquid feed (product or water) to a maximum;
- switch off the motor, but leave the program control on;
- apply the brake;
- after the bowl has stopped completely, dismantle, clean and check all parts
carefully;
- evaluate all the possible causes of troubles reported in § 10.3.6;
- do not operate until the cause of vibration has been located and eliminated.
ATTENTION
Do not disassemble any part of the separator or of the inlet-outlet flow unit before the bowl is
completely standstill.
CHECK THE BOWL MOTION STATE LOOKING THROUGH THE CIRCULAR SIGHT
GLASS OBTAINED ON THE FRAME (see fig 2.1).
Figure 2.1