SPRT
®
SP-TL31Thermal Label Printer User’s Manual
5
Chapter 3 Methods of Use
3.1 Operation Steps
3.1.1 Paper Installation
Open the cover and fill the paper:
1. Open the paper compartment cover and adjust the position of the paper limit block so that the
paper can be put in smoothly.
2. Pass the paper through the limit slot of the paper limit block from the rear, and pull the paper
over the paper exit position. Pay attention that the thermal surface of the paper faces the direction of
the print head.
3. Adjust the paper limit block to a suitable position again according to the paper width, so that
the paper slides smoothly, and the paper will not swing left and right during the printing process.
4. Close the paper compartment cover, and pay attention to minimize the amount of label paper
left outside, so as to reduce the waste of paper rolls.
Automatic paper loading:
1. Adjust the paper limit block to a suitable position according to the paper width, so that the
paper slides smoothly, and the paper will not swing left and right during the printing process.
2. Pass the paper through the limit slot of the paper limit block from the back, and continue to
push the paper inward until the machine automatically sucks in the paper. Note that the thermal
surface of the paper faces the direction of the print head.
