13
[Format]
ASCII
HT
Hex
09
Decimal
9
[Description]
Moves the print position to the next horizontal tab position.
[Note]
• This command is ignored unless the next horizontal tab position has been set.
• If the next position of horizontal tab exceeds the printing area, the current position will be set as
[printing width+1].
• Horizontal tab positions are set with ESCD.
•If the current position is at [printing width+1] when receives the command, the printer will carry
out the action in row buffer and move the printing position to the Zero position of next line.
•The default value of tab position is every 8 standard ASCII characters (12*24) a tab.
•When the current row buffer is full, the printer will carry out the action below:
Under standard mode, printer prints the content of current row and sets the Printing position at
the zero position of next line
Under page mode, the printer begins a new line and set the printing position at the zero position
of next line.
[Reference]
ESC D
LF
[Name]
Printing and feeding line
[Format]
ASCII
LF
Hex
0A
Decimal
10
[Description] Printing the data in the print buffer and feeds one line
[Note]
This command sets the print position to the beginning of the line.
[Reference] ESC 2, ESC 3
FF
[Name]
Printing and feeding paper
[Format]
ASCII
FF
Hex
0C
Decimal
12
[Description] Printing all of the content in print buffer and returning to the standard mode, under
the standard mode, if the printer establishes in the black mark paper mode, then
printing the data in the buffer to feed paper to the black mark section, if haven’t
black mark, then feed the paper 30cm behind stop, the pre-print black mark
specification is showed in the appendix C. The pre-print black mark instruction.If
not at the black mark examine status and then only print the contents of buffer,
don’t feed paper.
[Note]
Clear the content in print buffer after printing.
