9
[Front Cover], and the printer's network port can be configured to DHCP mode.
The method of obtaining the network port parameters in this mode is as follows: turn on the
[Face], press the [FEED] key once, and close the [Face], the printer will immediately print out the
current network parameters (IP and other parameters) of the network port.
2. DHCP off: Press and hold the [FEED] key and turn on the [Face] to turn on the machine. After
turning on the key, do not release the key. Release the [FEED] key after the status indicator and
the out of paper indicator flash alternately. Press the [FEED] key four times again, close the
[Face], the printer's network port parameters will be restored to the factory default settings, you
can turn off the DHCP mode.
Note: The above operations need to be completed when the printer has paper.
2.3.3 USB Interface
The standard configuration of the SP-POS8810 printer is equipped with a standard USB printer
cable D-type data connection cable, which is used to connect the printer and the main device.
The printer's USB belongs to the type of slave device (DEVICE); the appearance and pin
definitions are shown in 2-4:
2.3.4 Bluetooth Interface
Handheld devices, notebook computers, or other information terminals with Bluetooth interface
can drive SP-POS8810 to print through the Bluetooth interface. The Bluetooth of the
SP-POS8810 printer is compatible with Bluetooth 4.2 Bluetooth specification, the power level is
Pin
Function
Notes
1
V Bus
Power +5V
2
Data-
Data-
3
Data+
Data+
4
GND
Power Ground
Fig.2-4 USB interface
Содержание POS8810 Series
Страница 18: ...16 Fig 2 7...
