5
020-053-UK R2
BoomPilot
®
systEM ChECk
After connecting the power connector, it is time to make a system check. To check the
system, it is necessary to have full GPS signal. To obtain full GPS signal, the vehicle must
be placed outside.
Check AUTOMATIC mode:
TJ744E Switch box:
Section switches should be in the OFF position when working in Automatic mode. The
Master switch will control the sprayer and should be ON to enable automatic switching of
the sections.
Figure 1-5: Automatic to All Booms On Mode
2.0 km/h
0.76 ha
Mark A
A
A
Matrix Pro:
•
Turn on the Matrix Pro console
•
Encode the number of sections
and the width of each
(Refer to the Matrix Pro user
manual)
•
Wait for GPS signal
•
Set the BoomPilot mode to
AUTOMATIC
◄Status Bar Icon will change
to green
•
Drive forward (> 2 km/h)
•
Observe that all valves open
•
Check that the valves close
when the Master switch is set to OFF
Check MANUAL mode:
TJ744E Switch Box:
•
Set the section switches to ON
•
Set the Master switch to ON
Matrix Pro:
•
Set the BoomPilot mode to MANUAL
◄Status Bar Icon will change to red
•
Check in the ‘Vehicle View Screen’ (Matrix Pro) that the section icons turn off and on
according to the valve/switch status
•
Observe that all valves are open
Содержание TeeJet TECHNOLOGIES BoomPilot
Страница 15: ......
