6. Check the fit of the outer cover on the
spa as you inflate the bladders, the
openings in the side of the cover should be
centered on all valves, and filter pump
connections (Fig 8). If not, let some air out
of the side tubes and adjust the cover to
center the inflation valves in the openings.
7. Close valves completely. Close zippers
on valve covers.
8. Inflate headrests and close zippers.
9. Detach inflation hose from pump unit
and replace with the bubbler hose located
on the back of the spa, being careful not to
cross-thread the fitting. Hand tighten the
nut. Use the Hose Fitting Wrench (Fig 1d)
if needed.
10. Line up the hose connections on the
back of the pump with the fittings on the
side of the spa (Fig 10).
11. Attach the hoses from the large fittings
on the back of the pump to the
corresponding fittings on the spa, being
careful not to cross-thread them. Hand
tighten the nut. Use the Hose Fitting
Wrench (Fig 1d) if needed.
12. Make sure that the filter pump inlet and
outlet are opened by turning the nozzles
counter clockwise (Fig 11).
NOTE: AFTER INFLATING THE SPA,
UNPLUG THE FILTER PUMP FROM THE
ELECTRICAL OUTLET BEFORE FILLING
WITH WATER.
A
B
C
Fig 8
Fig 9
Fig 10
Fig 11
8
SpaManual-latest update 07 2/2/07 4:15 PM Page 8
