OM_GS_0218
www.sportsafieldsafes.com
10
9
GENERAL
E-LOCK
SECURITY
CODE
SETUP
IMPORTANT: It is necessary to re-program your gun safe with a new security
code you have personally selected to provide maximum household security.
A security code is a series of entries on the keypad. An “entry” is a single press of
one button/digit. Your security code must be between 3 and 8 digits. Choose a
security code that is easy to use, but difficult to guess. A poor example would be
1-1-1-1 or 4-3-2-1-1-2-3-4.
Be careful in choosing your security code. You’ll want to be sure that you can
operate the unit quickly without making an entry error.
1.
All Sports Afield Haven, Preserve, Tac LZ and Journey Series come with a preset
factory code of [ 1 5 9 # ].
2.
For the Haven Series, you first have to wake the keypad up by pressing any
number on the keypad. Then, enter the code [ 1 5 9 # ]. You will hear a beep
with each button push. If the code was successfully entered you will hear two
beeps and the green light will illuminate. Open the door by rotating the handle
clockwise.
3.
For all other models including in the Preserve, Tac LZ and Journey Series, simply
enter the code [ 1 5 9 # ]. You will hear a beep with each button push. If the
code was successfully entered you will hear two beeps and the green light will
illuminate. Open the door by rotating the handle clockwise.
4.
With the door open, now rotate the handle counter-clockwise locking out and
extending the active bolts.
5.
Next, on the inside of the safe, near the battery compartment, locate the small
copper cap. Unscrew and remove the cap.
6.
Press and release the reset button. You will hear a beep. The yellow light on
the E-lock will illuminate so that you can enter your new code. You can only
enter a new code while the yellow light is on.
7.
Ensure your bolts are in the extended positon, enter your new security code
(between 3 and 8 digits).
8.
Confirm your new security code by pressing the [ * ] symbol
9.
DO NOT shut the safe door until you have confirmed your new security code at
least 3 times to insure the code has been saved and you can lock and unlock
the door successfully.
10.
Reinstall the copper cap over the reset button and close the door.
IMPORTANT: If the code fails, repeat the steps above until your code is accepted.
If the incorrect security code is entered 3 times you will have an automatic
lockout for 20 seconds before you can try your code again. If 3 additional failed
attempts are made, the keypad will lockout for 10 minutes.
