WARNING: YOUR SAFE IS DESIGNED TO SUPPORT ITSELF WHEN THE DOOR IS
OPENED. HOWEVER, CAUTION SHOULD BE USED TO AVOID TIPPING. WHILE SECURING
YOUR SAFE BE SURE TO HAVE A SECOND PERSON HOLD AND STABILIZE THE SAFE
TO KEEP IT FROM TIPPING, CAUSING INJURY, AND/OR DAMAGE TO THE SAFE AND
SURROUNDING STRUCTURES. FAILURE TO DO SO WILL COMPROMISE THE SAFETY,
SECURITY AND WARRANTY OF THE SAFE.
TOOLS NEEDED TO BOLT SAFE TO A CONCRETE SURFACE
DRILL / HAMMER DRILL
DRILL BIT – 1/2” ( for installing into concrete with provided hardware)
WRENCH / 11/16” (17MM) SOCKET
HAMMER
1.
Use the hardware provided or consult your hardware retailer for fastening
hardware for your particular mounting surface.
2.
Open your safe door and locate and remove the four black caps on the safe
floor. This will provide access to the factory drilled bolt down holes.
3.
To secure your safe to the floor it will first be necessary to drill pilot holes in
the floor surface.
4.
Drill the appropriate diameter and depth of pilot holes based on the type of
hardware being used and the type of floor surface. For the hardware provided
(concrete floor installation) we recommend using a hammer drill and 1/2”
concrete drill bit to drill holes the four corresponding holes in the concrete
floor.
5.
Insert and drive the plastic anchoring plugs into the pilot holes. You may need
to use a hammer to fully insert the plugs into the pilot holes.
6.
Secure the safe, by threading all 4 anchor bolts through the factory drilled bolt
down holes in the bottom of the safe and ratcheting down tight.
Make sure the metal washer sits on top of the rubber washer.
Tighten the bolt to compress the rubber washer between the safe
and metal washer. Failure to do so, will allow water to enter the safe
in the event of a flood.
7.
Replace the four black caps onto the floor of the safe.
13. SECURING YOUR SAFE
www.sportsafieldsafes.com
13
