1. Starting
Assembly
Place the pieces, as shown below, on the table.
1. Place the valve piston
1
into the V-Tube
2
as shown
and secure it into place using the screw fastening
3
(small opening).
2. Place the V-tube
2
into the handheld device
4
.
3. Place the mouth tube
5
into the V-tube
2
and fasten
it using the second screw fastening
6
(large opening).
4. Place the respiration bag
7
on the open end of the
V-tube
2
and the mouthpiece
8
on the opening end of
the mouth tube
5
.
Turning on
Press the Enter key for at least two seconds.
Turning off
Press the Enter key for at least three seconds. If not
used the device automatically shuts off after five minutes.
2. Set-up
Entering training duration, respiration rate, and bag size
After the device has been turned on press the key until the
desired symbol starts to blink.
WATCH for training duration
FREQUENCY for respiration rate
BAG for respiration bag size
Select with the and keys the desired value and confirm
it using the Enter key .
Setting ranges
• Training duration: 0 - 99 minutes
0 (zero) equals no fixed training duration.
• Respiration rate:
15 - 60 breaths per minute
0 (zero) respiration rate means no given breathing pace.
• Respiration bag size: 0,5 to 5,0 litre
Respiration bags are labelled with their size.
The respiration bag size has to be individually
determined for every user.
Screw fastening
with small opening
3
Individual
respiration bag
7
Handheld device
4
Mouth tube
5
Mouthpiece
8
6
V-tube
2
Valve piston
1
Screw fastening
with large opening
This document does not replace any other provided measures necessary for the operation/usage of this device. Read before
using the SpiroTiger
®
device the detailed instructions of the user manual! The complete manual can be downloaded from:
www.idiag.ch
-
Application, Downloads, SpiroTiger Sport, Handbücher
Battery compartment
User‘s Quick Guide
ST
GO
EN
idiag AG, Mülistrasse 18
CH-8320 Fehraltorf
Tel. +41 (0)44 908 58 58
Fax +41 (0)44 908 58 59
www.idiag.ch
