2
2 Physical and Electrical Specifications
Input Voltage: 10-30VDC
Power consumption:
- Active mode: 120mA @12VDC
- Low power mode: 15mA @ 12VDC
Operating temperature: -30
℃
to 70
℃
Storage temperature: -40
℃
to 85
℃
3 LED Indicators
There are 3 indicator LEDs on the device, which are used to indicate the status of cellular communications
and GPS, and to indicate when messages are created and transmitted.
The
orange LED
indicates communications status:
●
Off indicates modem is off
●
The device enters a sleep low-power state
The
RED LED
indicates GPS status:
●
Off indicates GPS is off
●
Indicates network status
●
The device starts normally
The
green LED
indicates GPS status:
●
Instruct to turn on the GPS, and the GPS works normally.
●
Implies that GPS has been successfully located
4 Tracking Behavior Summary
Nala applications address the needs of typical vehicle and asset tracking. Variations in
functional behavior for specific applications is controlled via parameters in the settings file.
1) Power State Reporting
The Nala can be configured to report power up and rebooting behavior in a variety of
ways depending on what is desired. Cold Boot, Warm Boot, and first GPS Acquisition are
reported if so configured following Power Up events, power cycling, commanded reboots,
1 Introduction
it
is a remote start and security tracking device that uses a GPS satellite receiver
to determine location information and an LTE transceiver to communicate information to
and from a land based server. This document outlines the operation and configuration of
the Nalaproduct line using the supplied tracking application. This document is user
manual for Nala.
