6
INSTALLATION
A cut-out should be prepared in the worktop as shown in Fig.2. Heat barriers must be fitted
to the front and back edges of the cut-out as shown in Fig.3 - Section B-B. The appliance
should be fixed in position using woodscrews fitted through the side flanges as shown.
A direct distance of 200mm must exist between the edge of the appliance burners and any
combustible material, unless protected by a layer of non-combutible material. All
combustible materials such as curtains and shelves must be kept well clear of the
appliance. Any fitments such as a cupboard above the unit must have a minimum
clearance of 500mm between the fitment and the top of the Panrest.
In the case of appliances that do not have grills fitted, the underside of the appliance must
be shielded. It is recommended that the shield be fabricated from non-combustible
material, but if the enclosure is manufactured from combustible material, then a minimum
air space of 100mm must exist between the material and the lowest part of the appliance.
Appliances fitted with a grill require that a grill compartment be created below the cut-out
as shown in Fig.4. The compartment must be completely lined with a non-combustible
material such as aluminium or stainless steel. The grill compartment must have ventilation
holes at the compartment floor level and additionally include an escape route to the
outside to prevent the accumulation of unburnt gasses. Any cabinets beneath the grill
compartment must be sealed to prevent the ingress of unburnt gas.
CONNECTION
Gas Connection
The gas connection is made to a 8mm Ø inlet pipe, beneath and to the rear of the
appliance. Prior to connection remove the plastic protection plug from the fitting. It is
recommended that the appliance be connected by copper pipe, rubber tubing MUST NOT
be used.
IMPORTANT
•
After installation the appliance MUST be tested for soundness
•
Test ALL burners on high and low flame for flame stability.
•
The gas supply input pressure MUST not rise or fall significantly from
nominal when ALL appliances connected to the supply are operated
simultaneously. If NOT installed to the manufacturers instructions detailed
herein, we the manufacturer can not be held responsible for any problems
that occur, or poor performance that is perceived/witnessed.
Содержание S-656/MK 12 series
Страница 2: ...2 ...
