Z100080
ZX-
1 Operator’s Manual
Spinergy/SMP
Page 32
WARNING
•
Do not sit in ZX-1 equipped wheelchair
while in a moving vehicle. Failure to com-
ply could cause injury to ZX-1 operator.
HANDLING
Avoid bumping or knocking ZX-1 control
system, especially the joystick. Use care
not to strike obstacles with the control
system or joy-stick while operating the
ZX-1. Do not drop the control system.
WHEELCHAIR TRANSFERRING
Undock ZX-1 from wheelchair and follow
wheelchair manufacturer instructions for
trans- ferring from your wheelchair.
AIRLINE TRAVEL
It is recommended when traveling with
your ZX-1 that you disconnect the battery
cables (See Figure 14).
Travel restrictions vary for lithium
batteries based on the country that you are
traveling in and the airline that you are
using. Please check with your local
authorities on the required lithium battery
air travel restrictions.
Steps to disconnect:
1. Remove carbon fiber cover.
2. Move controller and BMS away from
the top of the batteries. (Figure 14)
3. Disconnect all four (4) battery tab
connectors shown in Figure 14.
4. Place tab covers on battery tabs. (Figure
14)
5.Replace controller with BMS on top of
the velcro strap. (Figure 14)
6. Replace carbon fiber cover.
Figure 14
