Operator
’s Manual – Spider CROSS LINER
60 / 64
7.2 WINCH TROUBLESHOOTING
Failure
Probable cause of failure
Repair
The drum is not rotating
Lack of oil in the hydraulic system of the machine
Add hydraulic oil
Jerking motion of the drum
Lack of oil in the hydraulic system
Add hydraulic oil
The drum rotates only until the oil gets
warm
Worn hydraulic motor
Replace the hydraulic
motor
Low engine speed
Increase the engine
RPM to maximum
The winch is too noisy
Worn bearings of the winch drum
Replace the bearings
7.3 REMOTE CONTROL TROUBLESHOOTING
The table below lists malfunctions that are signaled by LEDs on the Transmitting Unit and the solution to those
malfunctions. If the problem persists after attempting the suggested solution, contact the support service of the
Machine Manufacturer.
Failure
Probable cause
Repair
The green LED blinks
fast.
The red LED
¹
blinks for
3.5 minutes.
The battery is not sufficiently
charged or the Transmitting
Unit has been on for eight
hours
².
The battery needs to be replaced
with a charged one
The green LED repeats
one of the following
sequences: ONE or
TWO blinks and a
pause.
The red LED
¹ blinks for
3.5 minutes.
The green LED repeats
the sequence: three
blinks and a pause.
The red LED
¹ blinks for
3.5 minutes.
The Transmitting Unit has been
on for eight hours
²
You need to switch off the
Transmitting Unit and start the
Radio Remote Control again.
The green LED is off.
The red LED
¹ has ONE
very long blink.
The Transmitting Unit does not
work correctly.
Contact the support service of the
Machine Manufacturer.
At Radio Remote
Control start up,
the green LED is off
and
the red LED
¹ has ONE
long blink
³.
The STOP pushbutton is
pressed.
Unlock the STOP pushbutton.
At Radio Remote
Control start up,
the green LED is off
and
the red LED
¹ has TWO
long blinks
³.
The Transmitting Unit does not
work correctly.
Contact the support service of the
Machine Manufacturer.
At Radio Remote
The battery is very low.
The battery needs to be replaced
with a charged one
