Spellman LORAD LPX-200, Руководство оператора

Страница: 15 / 61

LPX-200
Industrial Imaging System
2-1 Chapter 2: Preparation for Use and Shipment
Chapter 2:
Preparation for Use and Shipment
UNPACKING INSTRUCTIONS
The LPX-200 X-ray Unit is shipped in a single wooden
container. To gain access to the unit, perform the following:
◆
Remove the top cover from the crate.
◆
Carefully lift each component from the container.
◆
Perform a thorough visual inspection on each
component.
If damage to any component has occurred, immediately
contact the carrier. Keep all damaged containers until the
carrier completes an inspection by the carrier. If it is
necessary to re-package and ship the unit, follow the
instructions outlined under
“ Reshipment Guidelines ” .
Reshipment Guidelines
In the event that the LPX-200 X-ray Unit must be transported
or shipped, use the original wooden container and packaging
material whenever possible. If the original shipping material
is not available, comply with the following re-packing
guidelines.
1. Construct a wooden shipping carton for the
Tubehead Assembly similar to the one in Figure 2-1.
Build the carton so that the top can be completely
removed to facilitate packing and unpacking.
2. Cushion the Tubehead with 3" of shock absorbent,
foam type, packing material (MINIMUM). This
material MUST surround the assembly on all sides,
including above and below the Tubehead.
3. Affix supporting legs to the bottom of the carton.
Make sure the legs extend between 7 and 10 inches
from the edges as shown in Figure 2-1.
4. Pack the Control Unit in a container rated for 60 lbs.
Surround the Control Unit with a MINIMUM of 2"
of shock absorbent packing material (sheet or loose
type), including the top and bottom.
5. Pack the Cooling Unit in the same manner as the
Control Unit.
! WARNING !
The coolant solution is a flammable
substance and must be drained from
the Cooling Unit’s reservoir before it
can be shipped.