Spektrum AR9010, Руководство пользователя

Страница: 10 / 72

EN
10
Programming Preset Failsafe
During the binding process the bind plug is inserted in the bind port, then the
receiver is powered up. The LEDs in each receiver should blink, indicating that
the receiver is in bind mode. Now before binding the receiver to the transmitter
and with the receiver in bind mode, remove the bind plug. The LEDs will still be
blinking. With the control sticks and switches in the desired failsafe positions,
bind the transmitter to the receiver. Follow the procedures of your specific
transmitter to enter Bind Mode. The system should connect in less than 15
seconds. The receiver is now programmed for preset failsafe.
Note: Failsafe positions are stored via the stick and switch positions on the
transmitter during binding.
Receiver Power Only
• With SmartSafe or Preset Failsafe, when the receiver only is turned on (no
transmitter signal is present), the throttle channel has no output, to avoid
operating or arming the electronic speed control.
• All other channels are driven to their preset failsafe positions set during
binding.
Note: Some analog servos may coast slightly even though no signal
is present. This is normal.
Plugging in the Leads
Plug the servo leads into the appropriate servo ports in the receiver noting
the polarity of the servo connector.
Range Testing
Before each flying session and especially
with a new model, it is important to
perform a range check. All Spektrum
aircraft transmitters incorporate a range
testing system which, when activated,
reduces the output power, allowing
a range check.
1. With the model restrained on the ground, stand 30 paces (approx. 90
feet/28 meters) away from the model.
2. Face the model with the transmitter in your normal flying position and place
your transmitter into range check mode.
3. You should have total control of the model with the button depressed at 30
paces (90 feet/28 meters).
4. If control issues exist, contact the appropriate product support department.
Advanced Range Testing
For sophisticated models that have significant conductive material in them,
the Advanced range test using a flight log is recommended. The advanced
range check will confirm that the internal and remote receivers are operating
optimally and that the installation (position of the receivers) is optimized for the
Pull and hold the Trainer Switch
30 paces (90 feet/28 meters)