Speidel 41000-20, Официальное инструкционное руководство

Страница: 70 / 84

70
Brewing problem Troubleshooting
Wort fontains shoot up
when circulating Malt is too finely ground. Grind the malt
yourself if necessary
Pump clogged Insert the fine screen / filter cloth and
screen plate more thoroughly. Pour the
malt more carefully into the malt pipe. The
malt must not fall into the boiler!
Pump makes noise The pump seal is too strong tightened
(hand tight is sufficient) or not properly
vented. Clean if necessary.
Temperature start-up
time is very long Put the lid on during heating. Place the
Braumeister sheltered from the wind.
Condensation water
leaks out of the lid Set up Braumeister horizontally.
Circulation process
does not get going Check that the pump is working and
that it is vented. Check that the malt pipe
and seal with gasket are evenly
distributed.
Wort flows off too slowly
or not at all during lau-
tering Prick several times with a wooden spoon
from the top to the lower sieve plate.
Malt is too finely ground. Only break up the
grains, not grind them finely.
7.2 Troubleshooting
Do not repair the appliance yourself, but consult an authorised technici-
an. To avoid any hazards, a defective control unit / mains cable or other
electrical components may only be replaced or repaired by the manufac-
turer, our customer service or a similarly qualified person.
BREWING MISTAKES