Welcome to the Speed Queen
®
family. Thank you for your support of our truly commercial quality products. Our washers and dryers are
expertly engineered to deliver commercial performance, tested to ensure ultimate durability and built with American Pride. For more than 110
years, Speed Queen consumer laundry products have been manufactured in Ripon, Wisconsin, a place where pride of workmanship is not just
alive, but thriving and embodied by each individual who designs, tests, assembles or in some way touches a Speed Queen product. A special
thing happens when that pride is combined with the highest quality commercial materials and components…it leads to the ultimate reliability…
reliability measured in decades, not years. That’s legendary Speed Queen Quality.
Three (3) Screws
(Electric Models)
Installation
Parts included:
Welcome
1.
2.
4.
3.
5.
Electric models – connect electrical cord
with three-wire or four-wire plug.
Refer to installation instructions, which can
be found at speedqueendoc.net
6.
Wipe out inside of dryer.
7.
Plug in the dryer.
Start dryer and check that dryer is heating.
Position and level the dryer.
• Recommended rear clearance
minimum is 2 in (51 mm) for utility
connections and 6 in (152 mm) when
venting through rear of unit
Connect exhaust system.
• Dryer must be exhausted to the
outdoors
• Use 4 in (102 mm) rigid duct
• Maximum straight duct length = 65 ft
(19.8 m). Each elbow deduct 10 ft (3
m)
•
Sufficient make-up air must be sup
-
plied. The free area of any opening
for outside air must be at least 40 in
2
(25806 mm
2
) per unit
Gas models – connect gas supply pipe.
Gas service to a gas dryer must conform
with the local codes and ordinances.
Refer to installation instructions, which can
be found at
speedqueendoc.net
• Tighten all connections securely but
do not overtighten to avoid breaking
or bending the gas valve bracket.
Turn on gas and check all pipe
connections (internal and external) for
gas leaks by applying a non-corrosive
leak detection fluid to the fittings. If
bubbles are present then a leak is likely.
Retighten connections and recheck for
leaks.
Lint Filter Guard
(Optional)
