Assembly / Setup
0190103R2 Page 4 of 8
Tools
Required
4mm Hex
wrench
(included)
Figure 1
1/4” Washer
under plastic bracket
7mm x 30mm
JCWS
7mm x 30mm
JCWS
Rear security
bracket
1. Install security brackets
1. With the Sprout on worksurface, choose one rear security bracket.
(Bracket for Sprout 1.55, or Sprout Pro G2).
2. Install the rear security bracket with (2) 7mm JCWS.
Figure 1
. Be
sure bracket is snug up against Sprout before tightening.
3. Install the plastic retainer bracket (with slots) with (2) 7mm JCWS,
and (2) washers under the bracket.
4. Slide the bracket up tight to the Sprout Pro with the touch pad in
place to captivate the pad.
5. Tighten screws securely.
HP Sprout
computer
1. To adjust, tighten or loosen the nut 1/2 turn.
Figure 2
.
2. Push down the worksurface, then pull the release
handle to check the worksurface extension speed.
3. Repeat this procedure until the desired extension
speed is reached.
2. Column cylinder adjustment
Release handle
Cable adjustment
nut
The worksurface extension speed can be adjusted with
the cable adjustment nut located on the release handle.
Figure 2
Plastic retainer
bracket (with slots)
