Assembly Instructions
Important
Before you begin, read and comply with all safety and operating instructions,
and ensure all parts and correct quantities are included.
Any parts damaged during shipment must be reported within 5 days of receipt. To
report information regarding missing parts or damage, to purchase parts or acces-
sories, or if you have any questions, please contact us.
www.spectrumfurniture.com
800-235-1262, 715-723-6750
Thank you for purchasing Spectrum products!
0118905R1 Page 1 of 2
1. Assemble Slide Brackets
1. Attach the ‘L’ brackets to each outer slide with screws (included
with slides). The brackets need to be attached “inboard” (facing
each other).
Figure 1A
.
Multiple height positions / mounting
holes are available with the brackets-use the same hole position
on all 4 brackets.
2. Tighten the bracket screws securely.
3. Separate the inner from the outer slides using the black levers.
4. Raise the lectern up all the way and unplug the power cord.
5. Determine which side of the lectern you want the keyboard tray
installed (left or right-side). The tray should be installed under the
worksurface on the side opposite the rack cabinet using the pre-
drilled worksurface holes.
6. Attach each outer slide (‘L’ brackets) to the worksurface using
(4) #8 x 5/8” PHSM screws and pre-drilled worksurface holes.
Tighten the screws completely on one slide only-leave the screws
other slide slightly loose.
Figure 1B
.
Note: The keyboard tray may protrude up to a maximum of 3.9” [10 cm]
below the worksurface. If the lectern is used for ADA use, a higher ad-
justed worksurface will be necessary to provide ADA leg clearance. The
‘L’ brackets can also be adjusted to provide varied keyboard heights.
Figure 1A
#8 x 5/8” PHSM
(4 per slide)
XRS Elite
worksurface
Outer slide
Figure 1B
Outer slide
Screw
(included with slides)
‘L’ Bracket
Outer slide
‘L’ Bracket
(6) 0100167
8-32 x 1/2” PH
thread-cutting
screw
(8) 037542
#8 x 5/8” PHSM
(1) 050092
12” Slide set
(1) 0118160
Keyboard
Tray
Phillips
Screwdriver
Keyboard Tray for Freedom XRS Elite
™
55334
Tools
Required
