Cord Channel / Modesty Panel
for Flex Training Tables
Assembly Instructions:
Tools Required:
Phillips screwdriver
4mm Hex wrench (included)
Before you begin, please make sure all parts and proper quantities are
included. Any parts damaged during shipment must be reported within
15 days of receipt. To report information regarding damages or if you
have any questions, please call 1-800-235-1262.
Attaching cord channel to table
Cord Channel
37256 - for 48" table
37257 - for 60" table
37258 - for 72" table
Modesty Panel
37253 - for 48" table
37254 - for 60" table
37255 - for 72" table
Modesty Panel
Cord Channel &
Modesty Panel
Cord Channel
A. Flip the table upside-down onto a non-abrasive surface.
B. Remove the 4 rear-most PHM screws from each leg mounting plate.
C. Attach the front half of the cord channel to the work surface (through the leg mounting plates)
as shown using 1/4-20 JC bolts and tighten securely.
Figure 1
.
D. Attach the rear half of the cord channel to the work surface (through the leg mounting plates)
as shown using 1/4-20 JC bolts and tighten securely.
Note: The hole in the center of the mounting flange does not require a JC bolt into the work surface
To purchase parts or accessories, please contact us at
www.spectrumfurniture.com
1-800-235-1262
Thank you for choosing Spectrum products!
044541
1/4-20 x 20mm JC bolt
(13) for cord channel
(8) for modesty panel
(1) 025039
4mm Hex wrench
Figure 1
1/4-20 JC bolts
Rear half of cord
channel
Note: The hole in the center of the mounting flange does not require a JC bolt into the work surface.
E. Align the cord channel mounting holes from both halves, and attach together with JC bolts.
Note: The rear half will overlap the front, and the JC bolts will thread into the front half.
Front half of cord
channel
Work surface
JC bolt not
necessary here
Leg mounting plate
0106710X Page 1 of 3
